For those who have tiles at home, it is possible that at some point in time they have encountered problems with discolored, missing or damaged grout. Whether it is in the bathroom shower, kitchen countertop or backsplash or floor, when the grout weakens this will cause the room to look lackluster. As a matter of fact, this could make even the most stunning tiles seem totally unpleasant and unattractive. Fortunately, this problem can be fixed easily if you regrout the tiles. In order to make your job a lot easier, this article will provide several tips to assist you in regrouting tiles in any area at home.
Keep in mind that the ruined grout might not seem bad on the surface but the things that you are unable to see at the back of the tiles could lead to dangerous conditions. Most importantly, in case there is mold formation this could also lead to severe health problems, thus it’s time to call in the professionals, such as Bathroom Surgeon company.
At this point, let’s take a brief look on the use of grout in ancient times to present day.
Similar to most of the procedures and products used these days, grout started during the historical times. The marble masons who cut limestone sculptures and statues usually left deposits of limestone powder while making open-spaced stone flooring. Whenever this powder is combined with water, sand and clay, the end result would be a tough seal on the tile and below the ground. These concepts continue to be used nowadays, utilizing what is currently called “common grout.”
The grout available these days is a much more advanced mixture of epoxy or sand, sealant, dyes and hardening agents, compared to what was used in earlier times. The current modern-day materials are generally made from pretty products and in many instances, water will be the only added substance to be included before installation.
Tips on how to regrout tiles
First, you need to get items such as a grout saw and/or a small knife; mildew remover; a utility knife or a chisel; vacuum cleaner; grout; tile sponge; grout float and grout sealer.
How to prepare the tile before regrouting?
- First of all, you have to decide on the color grout. When planning to work on the entire floor or wall area, it is best to get the right color to match up with the tile. This is even more important when doing small grouting, because the color must complement the current grout.
- Next, scrub and clean up the tiles using household cleansing solution such as mildew remover.
- After that, by using a small knife or grout saw you can make cuts in the narrow areas and this can remove the grout lines.
- At this point, you are recommended to get rid of the excess grout by using a utility knife or chisel.
- Then, vacuum around the space of the tile to remove any excess debris or chunks.
- Check if some of the tiles need to be replaced. If this is the case, you should do this before regrouting.
- Lastly, you should clean the tile. Make use of any household solution to get rid of any dirt and scum.